Search Results for "processor"

...With version 2.0, the source code has been cleanly split into an application-oriented user library and a time-critical stack driver. The latter may be moved to a dedicated communication processor or into a kernel module to deliver enhanced performance while still keeping the API in user space. A full documentation of the stack is available on the web site: http://openpowerlink.sourceforge.net The following page can be used to report a security vulnerability: https://sourceforge.net/p/openpowerlink/discussion/

Arduino support for almost every classic tinyAVR device! Supports ATtiny 1634, 2313/4313, 24/44/84, 441/841, 25/45/85, 261/461/861, 87/167, 48/88, 43 and 828. Supports programming vis ISP, Serial (Optiboot - all parts with >4k flash, and all parts with 4k flash for which an 8k version is available) or VUSB (Micronucleus - where appropriate) There are 272 different versions of micronucleus built (and part of the 2.0.0-dev branch now), and optiboot will dwarf that number! 0 of those have been...

This library adds MIDI I/O communications to an Arduino board. MIDI over USB, Bluetooth, IP & AppleMIDI (see Transports). Active Sensing support. Compatible with all Arduino boards (and clones with an AVR processor). Simple and fast way to send and receive every kind of MIDI message (including all System messages, SysEx, Clock, etc..). OMNI input reading (read all channels). Software Thru, with message filtering. Callbacks to handle input messages more easily. Last received message is saved until a new one arrives. Overridable template-based settings. ...

XMOS based, USB2 audio card, low power consumption, small form factor, 8 synchronous input channels and 4 stereo output channels.

ADopenPOWERLINK is an open source Ethernet Powerlink Controlled Node (Slave) solution using the Analog Devices ADSP-CM408F mixed signal processor (http://www.analog.com), along with Altera FPGA as network communication processor. The solution is based on openPOWERLINK provided by SYSTEC electronic (http://www.systec-electronic.com), B&R (http://www.br-automation.com) and Kalycito (http://www.kalycito.com). This release contains the necessary and required packages and documentation to setup the power-link controlled node using Analog Devices ADZS-CM408 EZLITE development board (http://www.analog.com/en/processors-dsp/cm4xx/adsp-cm408f/products/cm40x-ez/eb.html) as application processor, and a Terasic DE2-115 Altera FPGA development board as a communication processor.

The FunnyRobot project designs an educational robot controller that is programmable via USB. Both the hardware and software are configurable and extensible. Users can build programs with a C++ library and run them under a real-time operating system.

This is the code for FIRST robotics team 166's 2008 robotics code. It is written in C, and is intended for use on the 2008 Innovation FIRST robot controller, which utilizes a microchip PIC18F8722 processor to control a FIRST robot.

MogoBot is a small stepper motor driven robot that can easily be used by adults and kids alike. The robot follows LOGO like commands. The robot utilizes a Z8 Encore processor, and Mitsumi Stepper motors for motivation.