Search Results for "voltage"

This software is used to extract operational data from the EPEVER Triron solar-PV controller, including its PV power output, battery voltage, load current, device temperatute, etc. Data collection is done in two halves: a client ("solatonclient") that talks to the controller via a serial port and RS-485 adapter, and a server ("solatonserver") that stores the information in files. The "solatonclient" sends information to the "solatonserver" over the network, and because it does not need to write to the file-system itself it can be run on a small computer such as a Raspberry Pi.

...This pulses are amplified and applied to a MOSFET device that had the searching coil in series with drain. The pulse will produce a magnetic field generated by the searching coil, and becose of eddy currents, the target will produce a very low corresponding voltage at the coil terminals. The mode this signal decay depends of target characteristics ( form, type, material ) and the distance. This is the signal we need to analyze, so it is supressed by two antiparallel diodes and passed to an operational amplifier . After amplification, the analog signal is read by one of analog input of Raspberry Pi Pico board and is analized by the software. ...