Search Results for "pwm"

Basic Octave implementation of the matlab raspi extension, allowing communication to a Raspberry Pi board to control its hardware.

A dynamic C library to control Raspberry Pi GPIO channels Supports all production models / all SOC This library has code to:- Read Raspberry Pi Information Perform basic GPIO functions • Set gpio as input or output • Read/Write gpio • Set pullup/down of gpio • Read the current gpio mode • Read gpio pull/up down (Pi4/BCM2711 only) Software PWM on all pins Hardware PWM support Read/Set PAD drive, hysteresis & slew settings I²C SPI

...Added avahi-autoip to assign link local address when no DHCP server available (allow direct control with a PC without local network). Updated openssl. Please note that pigpiod may conflict with clock peripheral. When i2s-DAC available( pigpiod uses PWM). Else, PCM is used Default pins: IR/LED Module IR Out: GPIO 17 | Pin 11 Report to IR Receiver Model Specs LED1 : GPIO 27 | Pin 13 LED2 : GPIO 22 | Pin 15 Rotary Encoder Module: PEC12 A : GPIO23 | Pin 16 PEC12 B : GPIO 24 | Pin 18 PEC12 1 : GPIO 25 | Pin 22 LED1 Always ON LED2 ON when PLAY Pins can be changed in /home/volumio/script.volumio.service/addons.py MicroSD cards need to be expanded

serialLCD is Arduino based open-source project. It contains ATmega8 with given firmware file & the arduino library. The ATmega8 can be replaced by ATmega168/328. ATmega8 uses its 8MHz internal oscillator to reduce hardware (atmega8 no-xtal bootloader is used). The arduino library uses SoftwareSerial internally to communicate ATmega8 via digital pin 6 (only for uno/duemilanove or clone with atmega8/168/328, not for mega & due). Only one wire simplex serial communication at baudrate 9600 is...