Search Results for "parallel"

Throughput testing, latency testing, jitter measurement, packet loss measurement, TCP testing, UDP testing, ECN testing, L4S testing, responsiveness testing, bounceback testing, one-way delay measurement, histogram reporting, multicast testing, IPv6 support, parallel streams, bidirectional testing, full-duplex testing, congestion-control testing, socket pacing, CSV output, embedded systems support Current release: 2.2.2, August 31, 2026 About iperf 2 and iperf3: Read about the differences between these programs at https://iperf2.sourceforge.io/IperfCompare.html Man page: https://iperf2.sourceforge.io/iperf-manpage.html Manual: https://iperf2.sourceforge.io/iperf2-user-manual.html

New LinuxQ83 kopernik 13.16 ,is a modern, lightweight Linux distribution focused on performance, usability, and innovation. It features the COSMIC Desktop, a next-generation environment written in Rust, offering high performance, stability, and memory safety. COSMIC provides a clean and customizable interface for efficient window and workspace management. The system is suitable for both older and newer hardware thanks to its low resource usage. LinuxQ83 also uses Nushell as its default...

...The library can be loaded using the Arduino IDE's Library Manager. Direct Memory Access (DMA) can be used with the ESP32, RP2040, and STM32 processors to improve rendering performance. "Four wire" SPI and 8 bit parallel interfaces are supported. Due to the lack of GPIO pins, the 8-bit parallel interface is NOT supported on the ESP8266. 8 bit parallel interface TFTs (e.g. UNO format mcufriend shields) can use with the STM32 Nucleo 64/144 range or the UNO format ESP32. ILI9341 and ST7796 SPI-based displays are recommended as starting points for experimenting with this library. ...

Freeware software for Raspberry PI 4B+ using GPIO and I2C connections with a hardware board with a 30 cm I2C cable (seed or qwicc) or 2m (proprietary eComet). Hardware will be available soon at http://electromaker.io. main features: max 150s measurement time, load measurement data to CSV file, measurement calibration, parallel measurement of 4 values, scale zoom in out, and move at X and Y axes For news and updates see twitter page.

...First search the less load average node, then launch the application on it, then using X11 forwarding display the application on master node screen. Using the script nodes you can also use your cluster for parallel computation. The main points of attention are: - thermal regulation of each nodes - intelligent task dispatching over cluster - personal data backup and restoration - embarrassingly parallel computation