Search Results for "pcb-gcode"

This firmware allows not only to have a cheap bridge between Wifi and serial, but also to have a web UI to configure wifi, to monitor 3D printer and even control it, and to make things easy, UI is fully customizable without reflashing FW. Firmware should work with any 3D printer firmware (repetier/marlin/smoothie ware using GCODE) if the serial connection has a correct setup. I currently use it with my personal flavor of repetier for Due based boards. The web interface files are present in the data directory but UI has its own repository ESP3D-WEBUI. Use GPIO2 to the ground to reset all settings in a hard way, 2-6 sec after boot / not before!! Set GPIO2 to ground before boot change boot mode and go to special boot that do not reach FW. ...

SmartKnob is an open‑source hardware/software hybrid rotary input device featuring software-configurable end-stops and virtual detents, facilitated by a brushless gimbal motor and magnetic encoder—offering programmable haptic feedback and a novel, tactile user interface. 240x240 round LCD ("GC9A01"), protected by 39.5mm watch glass on rotor. BLDC gimbal motor, with a hollow shaft for mechanically & electrically connecting the LCD. PCB flexure and SMD resistors used as strain gauges for press detection (haptic feedback provided via the motor). USB-C (2.0) connector for 5V power and serial data/programming (CH340). Versatile back plate for mounting - use either 4x screws, or 2x 3M medium Command strips (with cutouts for accessing removal tabs after installation).

This project is about a light controlling system with a 4 RGB-LED channels to run different modes: • autonomously w/o PC performing HSI2RGB transformations and running through the color hues (with dimmable brightness) • remote operated by PC or embedded user software using the provided C++ Software library (based on Boost libraries) • ideal platform for color experiments with your RaspberryPi The system consists of 4 layers: • PCB with Atmel ATmega16 and FT232RL USB interface (Eagle forat) • Firmware for applying PWM, UART communication and integrated colorspace transformations (AVR-ASM) • C++-Software for providing a HTTP-Server, a Dreambox picture grabber and basic light sequence player • HTML5/JavaScript application for remote controlling and configuring the system via Webbrowser Please use the SVN browser for accessing the whole development snapshot and getting an current tarball!

Barracuda is a circuit board analyzer that analyze PCB and make sure the new boards doesn't contain errors Barracuda has now his first release, The error detection works fine, but it require to much calibration to get good pictures.