Search Results for "motor controller"

Betaflight is flight controller software (firmware) used to fly multi-rotor craft and fixed wing craft. This fork differs from Baseflight and Cleanflight in that it focuses on flight performance, leading-edge feature additions, and wide target support. Betaflight supports a wide range of flight controllers with at least an STM32F4 MCU. You can use nearly any piece of modern hardware out there. Full telemetry and high refresh rate for receivers, camera and VTX control, RGB LEDs, and much...

PMC is an open project that aims to build the quality permanent magnet synchronous machine (PMSM) controller for use in a variety of scopes like RC or electric transport.

An ESP32-Dev WiFi focuser. DIY or PCB designs. (c) Robert Brown 2014-2025, Holger M, 2019-2021. All rights reserved. Code or portions of code may not be copied or used without appropriate credit given to authors. Spreadsheet to calculate what stepper motor to use. https://sourceforge.net/projects/arduinoascomfocuserpro2diy/files/Documentation/Nema-Stepper-Motors.xlsx/download Spreadsheets to calculate...

myFocuserPro is an ASCOM and Moonlite compatible stepper motor telescope focus controller (DIY) based on Arduino Nano/Uno. A popular DIY ASCOM focuser with more than 121,000+ downloads. (c) Copyright Robert Brown 2014-2024. All Rights reserved. Permission is granted for personal and Academic use only. Spreadsheet to calculate what stepper motor to use. https://sourceforge.net/projects/arduinoascomfocuserpro2diy/files/Documentation/Nema-Stepper-Motors.xlsx/download

An Arduino based controller for a DC motor focuser solution. Replaces RigelSys/JMI DC Controllers. Windows application and ASCOM driver available. Works with most DC motor solutions (eg RigelSys, JMI, Orion, Skywatcher etc). Feature rich and low cost. Build the controller for under $25. (c) Copyright Robert Brown 2014-2025. All Rights Reserved. Permission is granted for personal and Academic use only.

...It is equipped with a large B/W screen, two buttons, accelerometer, magnitometer, current and voltage sensors, light sensor, internal temperature sensor, battery-backed real-time clock, a buzzer and has connection ports for external speed sensor (motor Hall, phase or reed switch), a Bluetooth SPP dongle, up to three temperature sensors (TMP36, LM35, KTY83 etc), cadence sensor, throttle handle, output to controller throttle input. The project includes: The hardware (schematics & drawings) The firmware (microcontroller program) The software (for mobile phones and PC) Project developement is being tracked (in Russian) here: http://electrotransport.ru/ussr/index.php?...

ASCOM driver for the LittleFoot Elegance Photo (LFEP) telescope controller. Firmware 6.x is fully supported - firmware 5.x is partially supported (all LFEP features are available but configuration is only possible by handbox). Contains drivers for telescope, focuser, camera, filter wheel, roof controller and dew heater which shares a single connection to the controller.

Roundhouse is a pair of C based embedded software applications to drive model railroad stepper motor based turntables. It consists of a stepper motor code and controller code connected by an I2C network. Written in C for PIC18/PIC16s processors.

GPL National Instruments 4-axis motor controller driver for PCI and PXI 73xx series (7334/7344,etc.) boards. Requires Linux Kernel 2.4 or 2.6 for proper operation.

Stepper Motor Controller driver for Linux

...The project will help you to connect any arduino motor shield or other H-Bridges to the controller because it is open source and the output pins can therefor be changed as you like. You can upload a better modified version and improove this article by contacting me. With some pin changes you can port this code to other arduino boards.