Search Results for "arduino-homekit-esp32"

An STM32 Nucleo-144 development board with Arduino Uno Rev3 connectivity is interfaced via an EastRising Technology Co Ltd Shield PCB to the East Rising 800x480 pixel 7 inch LCD panel with resistive touch screen. A set of functions has been developed to drive the panel via SPI, which uses the RAiO Technology Inc RA8875 TFT-LCD controller IC. Test firmware was developed that uses this function set to explore and demonstrate the many capabilities of the panel.

...This library uses the SPI interface of the microcontroller and will require at least one dedicated pin for CS, plus the SO, SI, and SCK pins of the SPI interface. An interrupt pin is not required. Any Arduino IDE >= 1.0.0 should be fine. EtherCard is available for installation in the Arduino Library Manager. Alternatively, it can be downloaded directly from GitHub.

C and C++ library for the NIBObee, NIBO burger and NIBO 2 robots. The library contains libraries for AVR Studio and Arduino developement, USB drivers and the RoboDude programming software.

DEVELOPMENT OF THIS PROJECT HAS MOVED TO GITHUB, at https://github.com/simonjwright/cortex-gnat-rts This project contains various GNAT Ada Run Time Systems (RTSs) targeted at Cortex boards: so far, the Arduino Due (http://www.arduino.org) and the STM32F4-series evaluation boards from STMicroelectronics (http://www.st.com). It is intended that releases will allow the development of proprietary software (by the use of the GCC Runtime Library exception for project-developed code, and by only using manufacturer’s software where the same permission applies).

Designed for data-logging applications (weather, hydroponics, greenhouses, aquariums, home automation, power consumpion, solar or wind generators etc.), this solution can be useful also in alarms and burglar. Now you can develop MySQL and web enabled Arduino applications only working on Arduino and PHP. To keep ligth the Arduino Sketch, you can port all not realtime logic to PHP side. At the end your application will works on XQ+Arduino UNO even 24/7 with only 20 Watt AC power, and can be controlled by smartphone via WiFi or from Internet using some free dynamic IP. What more? ...

Smartcard access lib for Arduino based boards connected directly to a smartcard. This is currently a work in progress. Currently it is possible to communicate with a smartcard directly connected to a Arduino board or connected via a TDA8024T (or compatible chips. e.g. DS8024). All tests have been done with a smart card slot connected directly to the Aruino board.

Arduino class library for communicating with Modbus slaves over RS232/485