Search Results for "utf-8"

Keywords: Hamradio, Radio-amateurs, Maidenhead-, QTH-, (QRA-), Locator, Distance and Bearing Calculator, GNU/Linux command-line, LaTeX,- UTF-8-, ASCII-output, GPLv3; based on GM4ANB's book. "IO91pm is the Maidenhead-Locator for Maidenhead" ========================================= Background --------------- * For another little project, I wanted a QTH-Locator calculator for the UNIX (GNU/Linux, bash) command-line. * There are many, some very good, online QTH resources, but I wanted something that would work off-line...

Arduino Mega 2560 Code to that supports a standard Ethernet Shield . i.e. Drive Relays hence outputs to MFJ-993b. Supports Up and Down for manual L and C Tuning, Autotune On/Off, Antenna Selection 1/2 and 100ms Short /1000ms Long for Tune. Op Note 1: You may need additional power for the 5V relay board; sometimes you can power the 5V relay board from the Mega 2560 - but reset/start the device first and then connect power to the relay board. Op Note 2: You will need determine...

Amateur radio Short Wave Listener's logging software. Application was developed specifically for listeners of amateur frequencies. Application should be started with java 8 jre using terminal command 'java -jar swarlog.jar' from within the folder which contain file.

...It uses the an XMLRPC interface to talk to FLDIGI which is used as it's suite of modems. Configuration is very simple. Requires : Minimum FLDIGI 3.23.12 Minimum Java 8 (1.8)

Mirror directly approved by Phil Karn, KA9Q. The KA9Q NOS TCP/IP package began life way back in 1985 on a surplus Xerox 820 computer board running CP/M with a 4 MHz Zilog Z-80 CPU, 64KB of RAM and a 8" floppy drive holding all of 243KB. Later, it moved to the IBM PC with the 8088 and 80286 CPUs running MS-DOS. KA9Q NOS was only the second known implementation of the Internet protocols for low-end computers. Unlike PC/IP, KA9Q NOS could simultaneously act as an Internet client, a server and an IP packet router, and handle multiple client and server sessions. ...

...Just compile it by 'gcc elbug.c -o elbug' or use the ready-compiled file and copy elbug to user/local/bin. /* Call it as root. */ How to cable your homebrew elbug? Middle pad: +9V battery via Resistor 2k Left contact: -> DCD (9-pin plug: 1) (25-pin plug: 8) Right contact: -> CTS (9-pin plug: 8) (25-pin plug: 5) Ground: -pole battery (9-pin plug: 5) (25-pin plug: 7) /* by Günther Montag , ex- dl4mge now maintained by Patrick Strasser OE6PSE (trapicki) now actual version also at https://github.com/trapicki/elbug */

Mellow Panda is a collection of LINUX applications for control of radio receivers. It consists of a daemon and specialized clients (dedicated to each receiver model). There are example clients which Uniden Bearcat and Icom radios.