Search Results for "cable"

...Designed to enable test and development of modern and next-generation radio technologies, HackRF One is an open-source hardware platform that can be used as a USB peripheral or programmed for stand-alone operation. HackRF One has an injection-molded plastic enclosure and ships with a micro USB cable. An antenna is not included. ANT500 is recommended as a starter antenna for HackRF One. HackRF One is test equipment for RF systems. It has not been tested for compliance with regulations governing the transmission of radio signals. You are responsible for using your HackRF One legally.

FreqLength is a simple wavelength calculator that takes a given frequency as input and spits out various wavelength values for that frequency (full wave, half wave, etc.) If you'd like to donate there's several ways to do so: PayPal: https://paypal.me/gerowen Bitcoin (BTC): bc1q86c5j7wvf6cw78tf8x3szxy5gnxg4gj8mw4sy2 Monero (XMR): 42ho3m9tJsobZwQDsFTk92ENdWAYk2zL8Qp42m7pKmfWE7jzei7Fwrs87MMXUTCVifjZZiStt3E7c5tmYa9qNxAf3MbY7rD LiberaPay: https://liberapay.com/gerowen

L-Tuner Simulator is a small application to calculate the input impedance of the L matching network, the impedance of the load (cables + antenna), or to find the Antenna impedance giving the cable length. It was inspired by my MFJ-929 Auto-Tuner.

This software allows the user to specify various operating characteristics of the Micro-Fox 15 by Byonics, LLC. The Micro-Fox 15 is a frequency agile 2m low power transmitter typically used as the fox during amateur radio fox hunts. The operating characteristics of this device can be copied to and from the device, and can also be saved and loaded from a file. Please note that this software is distributed within the "Andy's Ham Radio Linux" software collection.

a simple c program for an serial elbug = electronic morse key.which is to be plugged to the serial port, its output is also a pin in the serial port. Just compile it by 'gcc elbug.c -o elbug' or use the ready-compiled file and copy elbug to user/local/bin. /* Call it as root. */ How to cable your homebrew elbug? Middle pad: +9V battery via Resistor 2k Left contact: -> DCD (9-pin plug: 1) (25-pin plug: 8) Right contact: -> CTS (9-pin plug: 8) (25-pin plug: 5) Ground: -pole battery (9-pin plug: 5) (25-pin plug: 7) /* by Günther Montag , ex- dl4mge now maintained by Patrick Strasser OE6PSE (trapicki) now actual version also at https://github.com/trapicki/elbug */

A gui based program used to download frequency and channel information to a Radio Shack Pro-89 scanner using a serial cable and a zaurus handheld computer. This code will be build using C++, QT and QextSerialPort.