Search Results for "24/7"

...It can handle horizontal and vertical offset alignment , offset in transitions. cant, Import form LANDxml and other formats , exports to Landxml, GSI , Trimble ascii , Inroads ascii etc. The project is under Heavy development. Please report any issues to the ticket system. Tested Operating Systems Windows 7 / 8 / 10/ 11 64 bit Ubuntu 16.04 / 22.04 64 bit Deepin 15 64 bit Linux Mint 18.2 64 bit MXlinux 21

...Application closing error fixed. ================================== ======================================= SYSTEM REQUIREMENTS ======================================= Windows: 7/ 8 / 8.1 / 10 (Please note, the ARM version of Windows is not supported for now.) Processor: Intel Pentium 4 or later that's SSE2 capable Ram: 512MB (Min) Architecture: Both x86 and amd64 (x64) binaries are provided for Windows.

CTSoft can be used for configuring the following drives: Digitax ST Base Digitax ST Indexer Digitax ST Plus Digitax ST EZMotion FXMP25 Field Controller Mentor MP Unidrive 'Classic' in open-loop, closed-loop vector and servo modes Unidrive SP open-loop, closed-loop vector servo modes and regen mode Commander SK drives Commander GP20 Drive in open-loop, closed-loop vector Unidrive ES open-loop, closed-loop vector and servo modes Unidrive PV CTSoft system requirements: Pentium IV 1000MHz or better recommended Windows 7, Windows Vista, Windows XP or Windows 2000 is required. Internet Explorer V5 or later should also be installed Absolute minimum of 800x600 screen resolution. 1024x768 is recommended as a minimum. Adobe Acrobat 5.05 or later (for parameter help) 256MB RAM Microsoft .NET Framework Version 2.0 Note that you must have administrator rights to install CTSoft If you have a previous copy of CTSoft installed you must uninstall it first.

A robotic DIY styrofoam cutter consisting of one rotational and two translational axes. It cuts a variety of shapes out of styrofoam-like materials using a hot wire. This project documents the necessary hardware and software parts. Don't miss the follow-up project at http://raumschaum.org Its goal is to further develop hardware and software into an user friendly application.

CSGCAD is a CAD application written in Qt/C++ that renders 3D graphics using a constructive solid geometry engine based on GLSL. This application is still far from completion, help is welcome