Search Results for "linux rm-rf"

... has an injection-molded plastic enclosure and ships with a micro USB cable. An antenna is not included. ANT500 is recommended as a starter antenna for HackRF One. HackRF One is test equipment for RF systems. It has not been tested for compliance with regulations governing the transmission of radio signals. You are responsible for using your HackRF One legally.

OpenMQTTGateway project goal is to concentrate in one firmware different technologies and protocols, decreasing, by the way, the number of physical bridges needed, and hiding the different technologies singularity behind a simple & widespread communication protocol; MQTT. MQTT gateway for ESP8266, ESP32, Sonoff RF Bridge or Arduino with bidirectional 433mhz/315mhz/868mhz, Infrared communications, BLE, Bluetooth, beacons detection, mi flora, mi jia, LYWSD02, LYWSD03MMC, Mi Scale, TPMS, BBQ...

Client software for users of the Automatic Packet Reporting System amateur radio network.

This application is designed for a bi-directional data exchange between IOT platforms connected through a LoRa RF link and a centralised processing facility connected to a LAN through an UDP link. It can run on any hardware platform hosting a Semtech LoRa module connected through a serial link and a network adapter. It has been designed to run on the Libelium Meshlium platform but is also compatible with Windows and Linux operating systems. All needed information on the application...

RF-TrulyMagical is a spin-off of the RF-Magic device configuration software that comes with the APC220 wireless radio modules developed by APPCON TECHNOLOGIES. It is primarily intended as a cross-compatible solution for Linux/Windows users. Additional features include an inbuilt terminal making it easier to setup and communicate between the RF modules.

AVR beacon project utilizes a new approach to RF signal generation using SQDDS method (making RF signals directly from the software, based on a pre-calculated periodic bit-sequence). It is mainly used by the hamradio operators to set up various radio beacons for different purposes, mostly for radio waves propagation discoveries. CW (continious waves, Morze code) is a main modulation mode. Other modes like PSK and FSK are planned to implement in the future releases. User can enter any ASCII...