Search Results for "pid controller"

The Red Pitaya is a commercial, affordable FPGA board with fast analog inputs and outputs. This makes it useful for quantum optics experiments, in particular as a digital feedback controller for analog systems. Based on the open source software provided by the board manufacturer, PyRPL (Python RedPitaya Lockbox) implements many devices that are needed for optics experiments with the Red Pitaya. PyRPL implements various digital signal processing (DSP) modules (see features below). It allows...

.... * Soil Moisure Sensors are responsible for sensing if the soil of irrigated flowers are wet or not. These sensors are attached to the Sensor Controller Module via slow speed I2C bus. The modules use 2-pin probes and drives them with 4 kHz square wave in order to avoid oxidating the probes. In my implementation I used these small water pumps from Conrad: http://www.conrad.hu/conrad.php?name=Products&pid=539090 The whole system is powered by a 12V / 4A SMPS.

The code in this repository is old and I don't like the sourceforge interface. You can get the code that was running in the video here: https://github.com/arduinoNube/digital-pid-classroom-demo This was a class demonstration I developed for a mechatronics class. Feel free to contact me about getting design files, code, a little help, etc. It demonstrates proportional, integral, and derivative controllers and their features as well as anti-windup and control loop update rate. It uses...

...SID is tested with - HAKKO 907 handpiece - HAKKO 908 handpiece - QUICK 907A handpiece (HAKKO klon, different characteristics of the sensor) - GORDAK handpiece (HAKKO klon, different characteristics of the sensor) - ATTEN handpiece (HAKKO klon, different characteristics of the sensor) - NONAME HAKKO klon (identical RTD characteristics) - SOLOMON SL 10 - SOLOMON HQ 10 - SOLOMON HQ 30 - WELLER PES-51 SID display's data on 16x2 LCD, it has USB port (used attm only for bootloader) and it outputs debug info on serial port of the mcu. It features fully tunable (no auto tuning so far) PID controller for the tip temperature.

This low cost project is a RC servo like position control of one or two geared motor(s) with a pot as angle feedback. You can send the arduino microcontroller a value from 0 to 1023 and the arduino will control the motor speed and direction to reach your target value. The PID algorithm will insure that the motor will not get into hold vibrations if the pot has some influences. This article will describe where you have to take attentions and what you have to setup to get the best results. The project will help you to connect any arduino motor shield or other H-Bridges to the controller because it is open source and the output pins can therefor be changed as you like. ...