Search Results for "vcc"

W25qxx, N25Qxx, and other SPI FLASH drivers for stm32 HAL.

...For SGB180 - 64 pins LOOOT of CODE memory. 256KB All pins are grupped by Ports, in according to MSP430FR5994 Datasheet info. All Pins Support Capacitive-Touch Capability With No Need for External Components 1.8 V to 3.6 V VCC Ultra low consuption (30nA in Sleep mode, 450 nA in Stand-By mode with RTC, 120 μA/MHz in Active mode) Five Power modes All external circuits are placed on PCB. No need any additional motions for start using SGB180. Connect supply voltage only. HFXT(16 MHz) crystall can be placed or not. So, you can choose external high frequency crystall youself. ...

VCC emulates the Tandy Color Computer 3 (coco) and peripherals needed to run older software on modern hardware.

Currently this program will play many of the samples and snippets of notation from The Avalanches song "Frontier Psychiatrist;" I built this for my final project in my Theory of Current Music class at VCC. Soon you will be able to add your own samples, graphics, and temporal settings and then save the file in a sharable format.

...A 5-way cable is required to connect the microcontroller to the port; wiring information is given in the included manual page. Remember that a clock source is required in order to program the device, and that EA must be tied to Vcc when programming the internal flash memory. Note that since prog89S52 uses ioperm() and friends to access the underlying port hardware, you may need to run it as root. Both binary and source may be freely distributed and modified, but both are provided without any form of express or implied warranty.

...Most of the changes were to utilize the digitalWriteFast() function for I/O pins **HOW TO USE** WIRING Ensure all pins are hooked up correctly: DB0 - DB015 to Digital Pins RD pin connected to 3.3V LED-A pin connected to 5V via ~20 Ohm resistor Vcc to 3.3V & GND to GND SOFTWARE 1. Add all files/folders to a folder named UTFT inside "libraries" folder in Arduino main install folder. 2. Unzip the "examples.zip" & "tools.zip". 3. Restart Arduino software. 4. Open "HW_Teensy3.h" & change the const int PIN0 - PIN15 to correct I/O pins on the Teensy 3.0 that are attached to DB0-DB15 accordingly, then save the file. 5. ...

Drivers Template Library for WinNT/2K(ME)/XP. At this time required VCC 6.0(5.0) and DDK.

Tools for Cisco IOS devices management. Short device inventory listings; ATM: PNNI topology reports, complete VCC reference, VCC status report, VCC tracking tool; MPLS: TDP/LDP/IS-IS topology reports, VRF inventory reports; Cisco72XX bandwidth points ana

Virtual Community Center (Chat, Voice, IVR, Email)