Search Results for "pcb-gcode"

...Access the embedded webcam feed and watch remotely how your printer is creating your newest thing. Get constant feedback regarding the current progress of your print job. Take a look at the integrated GCODE visualizer to see a rendition of the GCODE you are currently printing. Keep an eye on the temperatures of your hotends and print bed and adapt them on the fly. Move the print head along all axes, extrude, retract or just define your own custom controls.

This firmware allows not only to have a cheap bridge between Wifi and serial, but also to have a web UI to configure wifi, to monitor 3D printer and even control it, and to make things easy, UI is fully customizable without reflashing FW. Firmware should work with any 3D printer firmware (repetier/marlin/smoothie ware using GCODE) if the serial connection has a correct setup. I currently use it with my personal flavor of repetier for Due based boards. The web interface files are present in the data directory but UI has its own repository ESP3D-WEBUI. Use GPIO2 to the ground to reset all settings in a hard way, 2-6 sec after boot / not before!! Set GPIO2 to ground before boot change boot mode and go to special boot that do not reach FW. ...

...We designed an affordable motherboard that runs the Relativty Firmware, it is based on the Atmel SAM3X8E ARM Cortex-M3 processor and uses an MPU-6050 as it’s IMU. The naked PCB and the components to solder on, cost in total about 25 dollars.

matterQ is a simple Raspberry Pi based 3D print server based on the lprng spooler and the austerusG serial gcode host.

GComb is an open-source quick and easy Java tool intended to ease the lives of all 3D printing hobbyists by providing a look inside a “sliced” GCode file and a better view of what is going to be printed, before it is printed. It works by parsing GCode files and producing an image for each layer of the printed object, any of which can then be viewed. GComb was originally written on Mac OS X using Eclipse with Java version 1.7.0_25, and was made for a Makerbot™ The Replicator Dual printing Skeinforge 50-generated GCode files. ...