Search Results for "web based system"

This firmware allows not only to have a cheap bridge between Wifi and serial, but also to have a web UI to configure wifi, to monitor 3D printer and even control it, and to make things easy, UI is fully customizable without reflashing FW. Firmware should work with any 3D printer firmware (repetier/marlin/smoothie ware using GCODE) if the serial connection has a correct setup. I currently use it with my personal flavor of repetier for Due based boards.

MeshLab is an open-source, portable, and extensible system for the processing and editing of unstructured large 3D triangular meshes. It is aimed to help the processing of the typical not-so-small unstructured models arising in 3D scanning, providing a set of tools for editing, cleaning, healing, inspecting, rendering and converting this kind of meshes. MeshLab is mostly based on the open source C++ mesh processing library VCGlib developed at the Visual Computing Lab of ISTI - CNR. ...

Marlin is a popular open source firmware for the RepRap family of 3D printers. It is straightforward, reliable, extensible and adaptable, which is why it is used by many respected commercial 3D printer vendors as well as hobbyists. It runs on inexpensive 8-bit Atmel AVR micro-controllers, with added support for 32-bit and ARM-based boards. Marlin builds can be small enough for use on a headless printer with only modest hardware, and features can be enabled as-needed.

The DarkLight Cover/Calibrator (DLC) is a DIY project to build a motorized telescope cover, flat panel, or a combination flip-flat system. Its modular design supports various setups: a 12V light panel without a servo for a wall-mounted calibration panel, a servo-only cover for sky flats, or both integrated into a flip-flat mechanism. The DLC also includes optional dew heating to reduce extra equipment and cabling. With available drivers, it works with ASCOM or INDI. We’re excited to...