Search Results for "data.6bin"

...The open source system for processing and editing 3D triangular meshes. It provides a set of tools for editing, cleaning, healing, inspecting, rendering, texturing and converting meshes. It offers features for processing raw data produced by 3D digitization tools/devices and for preparing models for 3D printing.

...Firmware should work with any 3D printer firmware (repetier/marlin/smoothie ware using GCODE) if the serial connection has a correct setup. I currently use it with my personal flavor of repetier for Due based boards. The web interface files are present in the data directory but UI has its own repository ESP3D-WEBUI. Use GPIO2 to the ground to reset all settings in a hard way, 2-6 sec after boot / not before!! Set GPIO2 to ground before boot change boot mode and go to special boot that do not reach FW. Currently, boot takes 10 sec - giving 8 seconds to connect GPIO2 to GND and do a hard recovery for settings. ...

...It is particularly useful in 3D printing scenarios: the repairing functions provided by ImatiSTL bridge the gap between printable meshes and real-world meshes with diverse potential defects and flaws (e.g. degenerate triangles, self-intersections, surface holes, ...). ImatiSTL provides both functions for local mesh repairing and methods for global remeshing. Local repairing is useful when the available data must remain exactly as it is in the input STL file, whereas global remeshing may fix even highly corrupted meshes at the cost of a small distortion in the resulting fixed mesh.