Search Results for "setup-subversion"

This firmware allows not only to have a cheap bridge between Wifi and serial, but also to have a web UI to configure wifi, to monitor 3D printer and even control it, and to make things easy, UI is fully customizable without reflashing FW. Firmware should work with any 3D printer firmware (repetier/marlin/smoothie ware using GCODE) if the serial connection has a correct setup. I currently use it with my personal flavor of repetier for Due based boards. The web interface files are present in the data directory but UI has its own repository ESP3D-WEBUI. Use GPIO2 to the ground to reset all settings in a hard way, 2-6 sec after boot / not before!! Set GPIO2 to ground before boot change boot mode and go to special boot that do not reach FW. ...

Welcome to the KlipperOS Live USB! I created this to simplify Klipper setup and avoid having to purchase a pi. Before you begin, please read all of the README on the GitHub at github.com/MaxR-712/klipperOS.

Welcome to the my3D printer Tevo Tarantula site. Here you find find firmware, upgrades, modifications and new parts to make your Tevo Tarantula even better. Full users guide taking you from once assembled to printing. Step by step detailed instructions. Also see my 3D Projects site at https://sourceforge.net/projects/my-3d-projects