Paul Gorlinsky

Erich I would be able to setup a Teams Session to show the code I have … Paul On Jan 6, 2023, at 10:50 AM, Erich erich_st@users.sourceforge.net wrote: Hi Paul, no private responses, please. When I referred to failing code I was thinking of a piece of code that can be compiled to debug an issue, not code screenshots. Just a few comments regarding the code in the screenshots: I can see that the return code for RexxRegisterSubcomExe and RexxRegisterExitExe isn't checked. Checking it might give an indication...

I'll add code to reflect the RC for the RexxRegister.. calls and QueryExit.. I can’t give you proprietary code - it is integrated with our virtual tape appliance… On Jan 6, 2023, at 10:50 AM, Erich erich_st@users.sourceforge.net wrote: Hi Paul, no private responses, please. When I referred to failing code I was thinking of a piece of code that can be compiled to debug an issue, not code screenshots. Just a few comments regarding the code in the screenshots: I can see that the return code for RexxRegisterSubcomExe...

On Jan 6, 2023, at 10:50 AM, Erich erich_st@users.sourceforge.net wrote: Hi Paul, no private responses, please. When I referred to failing code I was thinking of a piece of code that can be compiled to debug an issue, not code screenshots. Just a few comments regarding the code in the screenshots: I can see that the return code for RexxRegisterSubcomExe and RexxRegisterExitExe isn't checked. Checking it might give an indication what happens. Same for RexxQueryExit(). Why are rexx.dll and rexxapi.dll...

<meta http-equiv="content-type" content="text/html; charset=utf-8">Rebuilt my entire all with the 5.0 codeSent from my iPadOn Jan 3, 2023, at 6:23 AM, Rony G. Flatscher <orexx@users.sourceforge.net> wrote:Hmm, so did you rebuild your app with ooRexx 5.0 and it did not work? Or were you using the 4.2 build against 5.0? If so one problem could be that the bitness does not match in the case that 4.2 was built for 32-bit and your 5.0 is 64-bit. It is hard to come up with other ideas/speculations as...

<meta http-equiv="content-type" content="text/html; charset=utf-8">I uninstalled 4.x, then rebooted… installed 5 rebooted, and then rebuilt my application. After the failure, I uninstalled 5 rebooted, installed 4 and rebooted then rebuilt the application. No failure… Sent from my iPadOn Jan 2, 2023, at 6:29 AM, Rony G. Flatscher <orexx@users.sourceforge.net> wrote:Paul, are you sure that you have a clean install? What you experience may be caused by old code being picked up or by using a hard-coded...

Win server 2016, vs2022, RexxApi issues… 4.2 working, 5.0 fails

On several systems with RAID-1 setups - Clonezilla does not see the single logical drive, but instead the two raw drives. The problem is that if you proceed, backing up one of the drives, the timesstamp will be altered and a rebuild will be initiated in the best case, in the worse, both stamps will be altered and the RAID-1 image broken. DON'T use Clonezilla if the RAID-1 image is not detected. BTW just starting Clonezilla on these machines could alter the timestamps of the raid image...

I can wait ... Post to this when 3.5ga9 is release and I'll test it again... Tha...