Hi, I need redirect the incoming sip traffic from a softswitch, my question is how I register this sip trunk in opensips??.. Actually I have it registered in asterisk thus:
But I need implement load balancing to asterisk server.
My actual scenario: softswitch ------>asterisk
My future scenario: softswitch ------>opensips------->asterisk
Thanks in advance
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
My need is actually just to have a SIP proxy/gateway in between a SIP over UDP provider on the Internet, providing trunks for an internal MS Lync installation, which uses SIP over TCP… I'm not even sure I need the complications of OpenSIPS, and may go try it out on Asterisk, but any comments/recommendations are welcome. I followed the wonderful web "Getting Started" tutorial at http://www.opensips.org/Resources/GettingStartedTut which walked me through an install.. Unfortunately, the tutorial was based on 1.8 and I downloaded 1.9, and now I can't get OpenSIPS to start because of a "module 'httpd.so' not found" error..
I'd hate to go back to 1.8 and then have trouble upgrading to 1.9, but I can't find anywhere how to find/install this httpd.so file..
Can anyone point me in the right direction, or tell me I'd be better off with Asterisk?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have the same scenarior as Anonymos:
Asterisk1 ------> Opensips -------> Asterisk2
1000 is registered on Asterisk1. 1000 calls 1900 on Asterisk2 through OpenSips
But i don't know how to send INVITE request from Asterisk1 to Opensips and the Opensips route INVITE request to Asterisk2
Please give me some advices,
Thanks and Brs,
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi, I need redirect the incoming sip traffic from a softswitch, my question is how I register this sip trunk in opensips??.. Actually I have it registered in asterisk thus:
type=friend
silencesupp=hide
qualify=yes
nat=no
insecure=port,invite
host=ip-softswitch
dtmfmode=inband
disallow=all
canreinvite=no
allow=ulaw
allow=alaw
context=default
language=es
But I need implement load balancing to asterisk server.
My actual scenario: softswitch ------>asterisk
My future scenario: softswitch ------>opensips------->asterisk
Thanks in advance
i recommend this article, i think it contains useful information that you might need. i will also be working on load balancing next week, so maybe we can help each other out
take care
http://www.opensips.org/index.php?n=Resources.DocsTutLoadbalancing
I'm going to bump this, even though it's older.
I also need a set up similar to this, and there hasn't been a straight forward explanation about how without explaining the why who and whatfors.
I need assistance setting up a sip trunk in the manner that was mentioned above, and help in this matter would be very welcome.
And.. Me too..
My need is actually just to have a SIP proxy/gateway in between a SIP over UDP provider on the Internet, providing trunks for an internal MS Lync installation, which uses SIP over TCP… I'm not even sure I need the complications of OpenSIPS, and may go try it out on Asterisk, but any comments/recommendations are welcome. I followed the wonderful web "Getting Started" tutorial at http://www.opensips.org/Resources/GettingStartedTut which walked me through an install.. Unfortunately, the tutorial was based on 1.8 and I downloaded 1.9, and now I can't get OpenSIPS to start because of a "module 'httpd.so' not found" error..
I'd hate to go back to 1.8 and then have trouble upgrading to 1.9, but I can't find anywhere how to find/install this httpd.so file..
Can anyone point me in the right direction, or tell me I'd be better off with Asterisk?
Hello everybody,
I have the same scenarior as Anonymos:
Asterisk1 ------> Opensips -------> Asterisk2
1000 is registered on Asterisk1. 1000 calls 1900 on Asterisk2 through OpenSips
But i don't know how to send INVITE request from Asterisk1 to Opensips and the Opensips route INVITE request to Asterisk2
Please give me some advices,
Thanks and Brs,