1, Launch LibreCAD;
2, click on icon "Polylines" in main toolbar;
3, click on icon "Polyline equidistant";
4, right click twice(times depends on current action state), or click on the "Back" icon in "polylines" tool bar;
Results:
Back to main toolbar, and "polyline equidistant" action is suspended.
Please note:
1, "Right click" means reverse the action state one step, while the "back" icon in toolbars means "back to parent toolbar";
2, drawing toolbars do remember states before, and this is a feature by design to allow faster drawing;
say, you clicked "draw line, 2 points" in "lines", and switch to other drawing toolbars. "draw line, 2 points" will be activated when you switch back to "lines" toolbar next time.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
1, Launch LibreCAD;
2, click on icon "Polylines" in main toolbar;
3, click on icon "Polyline equidistant";
4, right click ONCE on the drawing area
Result:
The icon is not unselected which in contrary is the case when you replace "Polyline equidistant" with "Line with two points".
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Couldn't reproduce.
1, Launch LibreCAD;
2, click on icon "Polylines" in main toolbar;
3, click on icon "Polyline equidistant";
4, right click twice(times depends on current action state), or click on the "Back" icon in "polylines" tool bar;
Results:
Back to main toolbar, and "polyline equidistant" action is suspended.
Please note:
1, "Right click" means reverse the action state one step, while the "back" icon in toolbars means "back to parent toolbar";
2, drawing toolbars do remember states before, and this is a feature by design to allow faster drawing;
say, you clicked "draw line, 2 points" in "lines", and switch to other drawing toolbars. "draw line, 2 points" will be activated when you switch back to "lines" toolbar next time.
1, Launch LibreCAD;
2, click on icon "Polylines" in main toolbar;
3, click on icon "Polyline equidistant";
4, right click ONCE on the drawing area
Result:
The icon is not unselected which in contrary is the case when you replace "Polyline equidistant" with "Line with two points".
fixed in master: commit: 1a595db..d67834f
Works fine now.
Thank you.