This is an amazing tool, which I have been enjoying using very much, but it doesn't seem to work with the "banner motd x" command.
Does anyone else have this problem? It just hangs for me;
sw1(config)#banner motd (
Enter TEXT message. End with the character '('
This is using the following command file, I wondered if special characters where the problem so I tried various including open bracket, that's why it's in there. But I think now, it's something to do with expect because before the command is over the switch gives feed back "Enter TEXT message. End with the character '('" so is this confusing expect?
conf t
banner motd (
lalalala
lala
(
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
This is an amazing tool, which I have been enjoying using very much, but it doesn't seem to work with the "banner motd x" command.
Does anyone else have this problem? It just hangs for me;
sw1(config)#banner motd (
Enter TEXT message. End with the character '('
This is using the following command file, I wondered if special characters where the problem so I tried various including open bracket, that's why it's in there. But I think now, it's something to do with expect because before the command is over the switch gives feed back "Enter TEXT message. End with the character '('" so is this confusing expect?
conf t
banner motd (
lalalala
lala
(
Hi,
here you have a banner motd command explained:
IOS basic commands
Last edit: david_brent 2013-10-07