my AcerTV stereo card gets recognized as an AcerTV 98 card and it works pretty good I can change channels, I can switch sources to S-Vid and Composite but I soon noticed that in the evenings shows were in spanish and some had no audio at all. I went through the custom card config but when I get done with that it seems worse off, I can no longer change channels. I can't figure out how you are supposed to get all the stereo/SAP/Mono settings into the config file using btspy.
As an additional piece of info when I use DScaler I see the same problem but in there I can change the audio input and the correct audio is coming in on what dscaler thinks should be FM. So if I select the TV input in DScaler I get SAP and if I select FM I get TV. Does anyone know how to write a config file or inf file to clean this up?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
my AcerTV stereo card gets recognized as an AcerTV 98 card and it works pretty good I can change channels, I can switch sources to S-Vid and Composite but I soon noticed that in the evenings shows were in spanish and some had no audio at all. I went through the custom card config but when I get done with that it seems worse off, I can no longer change channels. I can't figure out how you are supposed to get all the stereo/SAP/Mono settings into the config file using btspy.
As an additional piece of info when I use DScaler I see the same problem but in there I can change the audio input and the correct audio is coming in on what dscaler thinks should be FM. So if I select the TV input in DScaler I get SAP and if I select FM I get TV. Does anyone know how to write a config file or inf file to clean this up?