Yago Araujo dos Santos

Hello, Yes!!! You're right. I was thinking about what wsunderm1 said and I reached at this point. I did this change and configured the non linear load yesterday, like you're saying now. Thus, the system worked. Thanks wsunderm1 so much for bring your points and suggestions, those help my thoughts and Davis for answer my question!

Hello, Actually there are 8 files to redirect inside my codes. This would be a little strange if I posted each file here, because it will be confuse. I just put all together and is in the same paste and way that I'm running here in my notebook. Good observation, but it does't represent my issue. Even though Defaultload could change my circuit, first of all I need to declare the defaultspectrum file and redirect it to harmonic mode work correctely. Now talking about the correct answer that I'm expecting...

Hello, Actually my system has 8 files to redirect. This would be a little strange if I posted each file here, because it will be confuse. I just put all together and is in the same paste and way that I'm running here in my notebook. Good observation, but it does't represent my issue. Even though Defaultload could change my circuit, first of all I need to declare the defaultspectrum file and redirect it to harmonic mode work correctely. Now talking about the correct answer that I'm expecting from...

Hello, I've been working with some simulations using IEEE-13BUS and harmonic analysis. I did small changes to adapt the system, because in parallel I'm simulating the same system in Matlab. I learned in the OpenDSS's docs how to declare non linear loads, and I didn't undertand how the example IEEE-13BUS is accusing harmonics frenquency in his "Monitors" without this kind of load. Can you help me? I'll disponibilize my system here with the changes that I did based on the real example founded in Paulo_Example>DSSfiles...

Hello, I've been working with some simulations using IEEE-13BUS and harmonic analyse. I did small changes to adapt the system, because in parallel I'm simulating the same system in Matlab. I learned in the OpenDSS's docs how to declare non linear loads, and I didn't undertand how the example IEEE-13BUS is accusing harmonics frenquency in his "Monitors" without this kind of load. Can you help me? I'll disponibilize my system here with the changes that I did based on the real example founded in Paulo_Example>DSSfiles...

Actually it ins't, unfortunately I don't know Mauricio Aredes. These studies are to my final college thesis. I'm a begginer in OpenDss, but I'm struggling to learn and develop this model. Thanks for your answer, best regards. Yago

Hi Sir, Can I control a controlled current source in OpenDss by a signal processed and constructed in Matlab? Whether I can, are there some exemples about this kind of aplication? I'm trying to do a active filter in OpenDSS, does it possible? My goal is to visualize the behavior of this equipment in some distribution system and to get some harmonic flow results and harmonic compensation.