David Barbulovic

Thanks Simon for the information. Regards, David

Hello again, sorry for the delay. We tried with the cycle time value of 50ms in Automation Studio for the PLC, but the PowerLink network will still restart itself. Here are the configuration files for the PLC MN and PC CN. We tried with a CN PC to see if the problem had to do with the Raspberry Pi2, but the problem still persists. Here are the files and screenshot of the problem. Regards, David XDD-File for CN Configuration for the PLC (Part1) Configuration for the PLC (Part2) IO-mapping Console_Part1_CN...

Hello. We have read through the files from Kalycito about OpenConfigurator. But no really explanation is gives to which of the PowerLink stack files should be replaced by the generated OpenConfigurator files. Our setup is one PC MN and one PC CN, where the XDD-files for the MN and CN are taken from the PowerLink stack and implemented in OpenConfigurator. So our question is, which files from OpenConfigurator should replace the files in the PowerLink stack? Is it sufficient to only replace xap.h in...

Hello. We are experiencing some issues with our PowerLink network. The Raspberry Pi2 CN restarts every now and then and it gives the error NMTEventNMTCycleError. Maximum Cycle time ( 100.000 microseconds) on the PLC has been set to see if it the cycle time is the problem, but the error still presist. So our question is: What causes our error so that the CN restarts after some time, although the Cycle time has been set to maximum? PolltimeResponse has been set to 15000 microseconds on the PLC. Regards,...

Hello, sorry for the delay. We solved the problem by working around it. We only used the operating system for the Raspberry Pi2 and install files for pcap from the Kalycito. Cmake install files was gained from their webpage. Thanks for the reply, and thanks Rama for your input. Regards David

Hello, sorry for the delay. We solved the problem the problem by working around it. We only used the operating system for the Raspberry Pi2 and install files for pcap from the Kalycito. Cmake install files was gained from their webpage. Thanks for the reply, and thanks Rama for your input. Regards David

Hello. We have been trying to setup the Raspberry Pi2 PowerLink communication by...