Tray Lornik

Here is a picture of the power brick's specifications:

I realize this is a veryold thread, but I figure it is still worth answering... The following was done using a multimeter and simply checking for connectivity... I also checked the unused pins for any possibility of an inline resister using an ohm meter and did not find anything. However, I cannot be certain that I did not miss anything, so proceed at your own risk. Took a while to find my old SIPIX A6 printer but here are the cable pinouts: PINOUT of included cable: FEMALE 9pin —--------------------------...

Take a look at the other forum post regarding the pinouts...it should tell you all you need to create a cable.

Here are some rough photos:

Here are some rough photos:

I realize this is a veryold thread, but I figure it is still worth answering... Took a while to find my old SIPIX A6 printer but here are the cable pinouts: PINOUT of included cable: FEMALE 9pin —-------------------------- \ R5 5 4 3 2 / \ 9 8 7 6 / ---------------------- SERIAL 9pin does not use pins 5,6,7, or 9 (above) MALE DIN 8 PIN (Listed as associated pin numbers from 9pin above) |------ NOTCH /-----V----\ | X 2 R5 | | 4 R5 3 | | X 8 | \---------/ X means unused Hope this helps someone get...