Simone Ferreira Vidille

Dear Dan, I installed DWSIM in Linux and was able to run the samples, except the dynamics samples. Do they work in this mode? I also tried to install the 32-bit version and use Wine but it gives me an exception error and DWSIM does not open. Any report of issues in Wine for last version? Thanks, Simone

ok, Dan, understood, thanks so much.

Dear Dan and everybody, In the attached file, an equilibroum reactor was modelled and run in Steady-State successfully. In Dynamics, few steps are allowed, but later there is a message saying that "Index was outside the bound of the array". Can you point out what is wrong? Thanks so much for your great help, as always, Best wishes, Simone

Dear Dan and everybody, When I run the sample without changing anything, sometimes I get errors, one of them is "Object reference not set to an instance of an object.". It is not always. I cannot understand the causes of that. Can you tell me, please, if I am doing something wrong? I attached one of the versions that I had the error. Thanks for all, Best wishes, Simone

Dear Dan and all, Once again with the questions, I was trying to run a 2-phase separator in Dynamics but there is an error in the PH flash in the vessel. I tried all solution options, different tolerances, different thermodynamics package, different solvers but always get the same issue. Can you tell me what I am doing wrong? Thanks, Simone

Dear All and Dear Dan, I am getting a message VALVE-2: Nullable object must have a value. I suppose it is realted to the zero flow of liquid in the bottoms of separator V-1. Have no idea what I´m doing worng. I hope you can help me, Best wishes, Simone