Suriya Prabha Sekar

Dear all, I am working on 3D indoor modelling using 3DTK and I am new on this topic. I have a doubt in filtering horizontal planes. Can someone explain why this particular formula is used for determining the horizontal planes? Horizontal planes if (1 - y/(sqrt(sqr(x) + sqr(y) + sqr(z))) < 0.1 Thanks, Suriya

Hello All, I am trying to get walls of certain rooms. Till now, I am able to get models of room with the following config, ;;;Configuration for hough transform MaxDist 500 ; maximum distance between point triple MinDist 50 ; minimum distance between point triple AccumulatorMax 20 ; plane detected if cell reaches AccumulatorMax MinSizeAllPoints 20 ; plane detection stops if only this percentage of points are left RhoNum 500 ; number of cells in direction of rho ThetaNum 360 ; " " " " " " theta PhiNum...

Hello JoSch, Dorit, Thanks for your help :). Regards, Suriya.

Hello Everyone, I am trying to build a model from the extracted planes. But I am not able to extract all four vertical (walls) and 2 horizontal (floor,ceiling) planes. I think the problem is with configuration i.e. distance between prev and curr plane is taken as 0.4 but the actual distance is always changing for each execution so its hard to figure out a threshold to set according to my data. Can someone help me with this. Also when I am trying to erase a redundant plane its exiting because of some...

Hello All, I am using show exe to display the extracted planes but its not getting displayed at centre of the opengl window. I have to do alot of zooming in and out every time. Then I tried save pos which saved the position of the scene and load pos which brought the scene to the stored pos. Now I am trying to understand pose.dat file format. Can I use this pose.dat file values as initial .pose file? If so how? saved pose.dat file values: 49.8184 -346.405 -2454.58 0.712251 0.2663 -0.60832 -0.227441...

Hello All, I am trying to build 3DTK WITH MODEL in Windows 10 64 bit with VS2013 (revision 1299) and with VS2015 (revision 1729) . But it gives me lot of link errors. Has anyone tried to work with model in 3DTK and able to build it without any error? If so, which revision did you use? If not, can anyone please guide me to build 3DTK WITH MODEL? Thanks.

Hello Dorit, I was able to detect all the planes with NR 5. Thanks for your help :)

Hello Dorit. I changed helper.cc but now I am not even able to view the data using show command :(. And if I use NR = 10 (before changing helper.cc), it is giving me following result (attached as picture), and plane was not detected, Thanks