Thank you Robert, I don’t know how I missed that. Stephen Stephen Symons Sent from Gmail Mobile on my iPad On Thu, Apr 4, 2024 at 5:30 AM brownrb brownrb@users.sourceforge.net wrote: Hi Stephen Look in myrotator_defines.h towards the end of the file //#define USEMYFP2ULN2003 if defined(USEMYFP2ULN2003) undef IN1PIN undef IN2PIN undef IN3PIN undef IN4PIN// DRVBRD_myFP2ULN2003 define IN1PIN 4 define IN2PIN 5 define IN3PIN 6 define IN4PIN 7 endif //#define USEMYFP2L298N // with ULN2003 if defined(USEMYFP2L298N)...
Hello, I am building my second myrotator... great project, thank you. I am certain that I found somewhere instructions on how to change pinouts that connect to IN1 to IN4 on the ULN2002 so I can use an existing Arduino/ULN2003 board for a myrotator. In spite of much searching I cannot find it again. I just want to change the Arduino mcode to use pins D4 to D7 instead of D5,6,9 and 10. Can you help me with this? Cheers, Stephen
Thanks for considering it Robert. It is still a great project and I will continue to use it with only a slight inconvenience in syncing. Cheers, Stephen
Hi Robert, That is great news. I will get busy building a board. Cheers, Stephen On Thu, Mar 9, 2023 at 3:57 AM brownrb brownrb@users.sourceforge.net wrote: Hi Stephen I have started the work to make a new v3 driver. Will let you know when it is ready to test. regards Robert sync rotator https://sourceforge.net/p/arduino-myrotator/discussion/general/thread/e2b06f7443/?limit=25#1db2/e3b0 Sent from sourceforge.net because you indicated interest in https://sourceforge.net/p/arduino-myrotator/discussion/general/...
Thanks for your reply. Isthere any hope of an update? Is the ascom driver source available? Thanks again, Stephen
Hello, Thanks for this design, it works well. I am wondering if myRotator ASCOM driver uses ICameraV3 Interface allowing user software to sync the rotator to an angle Thank you, Stephen Symons