Dave Marzetti

I have been trying for a few days to figure ths out. I need to connect two programs to control a Kenwood radio. The radio uses the following configuration, 4800,8,n,2. I have configured two pair of virtual ports, COM3 and CNCB0 and COM4 and CNCB1, When I run Hub4com with the following command, hub4com \.\COM10 \.\CNCB0 \.\CNCB1 it opens the ports at 19200,8,n,1. How can I change the baud rate and stop bits tomatch what the radio is expecting? I created the virtual pairs using setupg and tried with...