Peter Jakacki

TachyonESP files released for ESP32-C3

Hi John, Welcome to Tachyon Forth . Firstly here's a tip: Always best to start a new thread so the request is not lost and easy to find again. So rather than replying to this message, start a new thread (subject) and let me know the source you used. In the meantime use the files from my working set and try again: https://www.dropbox.com/scl/fo/n1tbumt8v8td1y780cylj/AM3BQqgabH8sSDjWUxgWL7M?rlkey=fyhlk6yai7yqydyt8ju7wimcv&st=esmqrrld&dl=0

Hi Andy, maybe I haven't been using the reply button. Read my latest post.

Hi Andy, I guess prerequisites are a fact of life and we have to start somewhere. But that's also where we ask questions and look for feedback too. I think I've also mentioned so many times the different terminal emulators that one can use, but I use minicom because it works properly and is a fully functional ANSI terminal emulator that can also keep up with high baud rates too. But when it comes to Windows I used to use and still use TeraTerm. But Mecrisp on the RP2040 only uses the hardware UART,...

Hi Andy, The Tachyon extensions to Mecrisp on the RP2040 were done as a bridge at the time I was looking at writing a Tachyon kernel for it from scratch. I played with the RP2040 for a while and I should come back to it I guess. I will dig out the board and check the files as well. Do you have some suggestions ?

Format any SDHC compatible card to FAT32 with variable cluster size

Format any SDHC compatible card to FAT32 with variable cluster size

Just to let you know then that TAQOZ is going through a revamp to V3 which also reduces the compiled kernel to the minimum to support loading EXTEND which will have make it a lot easier to make improvements. I have already redone all the number processing and dump routines, and now I am implementing the ABORT/QUIT console routines which will allow for interactive line edit and history as well.