Mladen Knezic

Hi Prajjwal, I do not think you can install 8139 network card driver on RPi as it uses completely different network interface. Therefore, you cannot use Linux Edrv Kernel Driver. You should use PCAP variant instead. Please follow the instructions for OpenPOWERLINK on RPi 2 (https://www.ethernet-powerlink.org/raspberrypi2). It should be the similar for RPi 3. Regards, Mladen

Hi, Thank you for information. I just checked. The app works fine with just EDRV debug level enabled. It crashes when DLL debug level is enabled (either with EDRV enabled or disabled). Is there any way to overcome this limitation? Some segments of DLL debug traces are very important. Best regards, Mladen

Hi all, Recently, I faced an issue with the demo_mn_embedded application running in debug mode. I am running Ethernet Powerlink (EPL) with MN on embedded platform (Terasic DE2-115 board) with debug level in driver daemon set to #define DEF_DEBUG_LVL 0xC0000003L so that EDRV and DLL levels are enabled. EPL network consists of two CNs also running on embedded platforms (Terasic DE2-115 board). When the debug flags are disabled, everything runs smoothly, hoewever, when I enable those two flags, application...

Hi all, I am trying to figure out how to store/restore parameters on dsPIC33 uC. Can you please tell me whether store/restore functionallity is supported for this uC? Regards, Mladen

Hi Alexey, You can find wireshark example captures on the following link: https://wiki.wireshark.org/SampleCaptures#ETHERNET_Powerlink_v2...

Hi Joerg, Thank you for your answer. We have not integrated sendqueue pcap interface...

One additional remark. We compiled the OPLK for Linux patched with RT_PREEMPT using...

Hi Joerg, Thank you for your answer. We have not integrated sendqueue pcap interface...