Marek Lorenc

Hi, In configuration wizard I can see possibility to setup up to 6 axis, I am totaly new on microcontrolers and would like to play a bit with them. At the moment I have Mega 2560 + RAMPS 1.4 on Ramps board exist 5 sockets for drivers. Does it mean that we can use them to drive 5 independent axis and use for that eCNC firmware?

Hi I just compiled eCNC and uploaded it to my Mega 2560, but after transfer RX led constantly blinking and on RS Monitor I can see $0.00:0.00:0.00:0.00:0:20 in endless loop.