Activity for Alberto Mardegan
-
Alberto Mardegan posted a comment on discussion Open Discussion
Hi! Just to announce that I just published a port of gl-117 for the Nintendo Wii: https://github.com/mardy/gl-117/releases It's very primitive, the menu on the screen are hard to click with the Wiimote, but it's playable. I don't know if it's just me being unused to flight simulators, but I find the plane quite hard to control; it may be that some parameters still need to be tweaked in order to play comfortably using the Wiimote's accelerometer. I might try to port LAC next. :-)
-
Hi! Here it is :-)
-
rotozoomSurfaceXY() adds color key flag to generated surfaces
-
`rotateSurface90Degrees` returns a locked surface
-
libimaevm: do not crash if the certificate cannot be read
-
Thanks Trevor, I tried playing with margins, but the result is not good, for several reasons: The same margin is applied on each side of the divider, while I'd like step #2 to start immediately after the divider (that is, steps should always be aligned to the top of the available space). Also, it may be that the model in the lower step is significantly taller than in the first one, and therefore it might need much less margin. The model stays aligned on the right of the quantities box; I'd like it...
-
Right at the start; especially at the beginning, when the model drawing takes less space, I might use even 3-4 steps per page. Near the end, as it gets taller, I would use 2 steps per page.
-
Thanks Trevor! I got up to that point, but the issue is that I'd like these two steps to fill up the vertical space in the page. Something like this: Or, with a mockup: Is it possible to achieve this with LPub3D currently?
-
Thanks Trevor! I got up to that point, but the issue is that I'd like these two steps to fill up the vertical space in the page. Something like this: Or, with a mockup: Is it possible to achieve this with LPub3D currently?
-
Hi Trevor, I'm attaching the file. I'm using LPub3D-2.3.12.89.1445_20190807-x86_64.AppImage, if that matters.
-
Hi there! I'm new to LPub3D, and I've got some issues in creating instructions with a vertical layout. The first issue is that I want to have two steps in one page, but I cannot get the two steps to fill up the whole width of the page: the two steps just lie there in the middle of the page, with plenty of space on the top and on the bottom. The second issue is that I cannot set a horizontal divider between them: the divider always gets placed on top of the first block. If I add a third step to the...
-
VOTE: refind
-
To be more precise: I get this problem with a Sony A700.
-
This happens again now (since a week).
-
ufraw and GIMP 2.6: error message whenever an image is imported
1
