User Activity

  • Posted a comment on discussion Open Discussion on GR FloorBoard

    Thanks. I compared your patch and mine and figured out what the differences were. Some of the differences were not intuitive (to me). The Patch Text Summary is useful, but I was surprised that the Save As did not save the text I was looking at: all I could see was a hex dump. I had to Select All and Copy and create text files manually, and then do a text file comparison.

  • Posted a comment on discussion Open Discussion on GR FloorBoard

    I keep my computer and the GR-55 on 24/7, but the GR-55 times out for some reason. When I return in the morning, the GR-55 is off. At that point, GR FloorBoard (GFB) appears to be in sync with the GR-55, but in fact it is not. Selecting a patch in GFB does not change the active patch in the GR-55, and vice versa. I cannot find a way to tell GFB "re-load everything from the GR-55". The only way I can figure out to recover from this situation is to terminate GFB and re-start GFB. Is there a better...

  • Posted a comment on discussion Open Discussion on GR FloorBoard

    When SLDN Gain is High, the CTL switches between very low level clean and very high level distortion. I was hoping for moderate level distorted and loud distorted. Clearly I misunderstand the meanings of the controls, or I have set up some Assign improperly. I've attached my patch.

  • Posted a comment on discussion Open Discussion on GR FloorBoard

    GR-55 and FloorBoard newbie here. I am trying to use the CTL foot switch to enable/disable the SLDN amp's Solo SW. I can get that working (although I am not sure whether the Solo light on the amp and/or the On/Off light on the Assign need to be lit). Whenever I save/write the patch, the CTL light is on and the Solo is enabled when I return to the patch. I want the patch to start off with the CTL light off and Solo disabled. What am I missing? Thanks! Jon

  • Posted a comment on discussion Open Discussion on GR FloorBoard

    Wow. Who knew how angle brackets would explode.

  • Posted a comment on discussion Open Discussion on GR FloorBoard

    I have selected perhaps 100 patches that I like, and I want to put them into the User area of the GR-55 in my preferred order. I cannot figure out how to do a drag 'n' drop (which I gather is not supported <if this="" is="" ever="" supported,="" i="" recommend="" offering="" the="" option="" to="" insert="" between="" two="" patches,="" rather="" than="" over-writing="" a="" patch="">).</if> I want to put all of my downloaded (g5l) patches into a folder, sorted by pre-pending "01", "02", etc to the...

View All

Personal Data

Username:
jonbondy
Joined:
2005-01-01 23:41:53

Projects

  • No projects to display.

Personal Tools