Activity for Marko Pinteric
-
Marko Pinteric modified a comment on discussion Open Discussion
Konrad, thanks for the response. I am using pre-compiled OpenHantek for Windows 10. My scope is Hantek 6022BE Best regards Marko
-
I am using pre-compiled OpenHantek for Windows 10. My scope is Hantek 6022BE Best regards Marko
-
Hello all, I am using OpenHantek for several years and each new version is better. For last few years I used version 3.2. Today I was working for about an half of hour and then program suddenly stopped working. When I restarted program, there was no error, plot appeared and after 2 s program simply crushed. I tried also the most recent version 3.2.3 with the same result. I was already scared that scope is somehow dead. (I was working with voltages 0V - 12V and I used 10x setting on probes.) Fortunately...
-
Hello all, I am using OpenHantek for several years and each new version is better. For last few years I used version 3.2. Today I was working for about an half of hour and then program suddenly stopped working. When I restarted program, there was no error, plot appeared and after 2 s program simply crushed. I tried also the most recent version 3.2.3 with the same result. I was already scared that scope is somehow dead. (I was working with voltages 0V - 12V and I used 10x setting on probes.) Fortunately...
-
PNG conversion no longer works with pdflatex
-
Marko Pinteric posted a comment on discussion NppExec
test.bat: @echo off echo %PROGRAMFILES(x86)% echo %PROGRAMFILES% When I run this...
-
NppExec problem with environment variables
-
Nodes for arcs, which angles are calculated simultaneously
-
It is still not available.
1