elythomaslumber

Does the conroller get enough power from an external power supply? If you have it connected to an USB port only, it needs a lot of power (up to 1A or more) for short time when WIFi starts to transmit. Thats too much for the port.

I have good experience with this isolated humidity sensor: https://www.reichelt.de/entwicklerboards-feuchtesensor-bodenfeuchte--debo-cap-sens-p223620.html?&trstct=pos_1&nbc=1 Additionally I insulated the sensor with a heat shrink tube. So there is no contact with water/humidity to metal. The sensor I used before which had contact with rain water doesn't survive a week. However I used these sensors in a different project.

Hi Robert, thanks again from my side. I will check with the complete 127-07 again firstly. I did not wait very long, not some minutes.... Cheers Hardy

Hi Kurt, Robert will answer but I have checked and found the libraries ("required" and "other") in the old zip-file of 122-4. As I remember I did not add or change them until the current release. However the last release which was working for me was the 127-4. The current 127-7 has a problem with the LUX sensor. It is found by the running SW but I get only static values. Maybe only a local problem for me. Cheers Hardy

OK, here it comes... - see attachment with my config and the messages. - please remember that I have the older 127-04 in a different folder and there the compiler works... C:\Hardy\Arduino\arduino-builder -dump-prefs -logger=machine -hardware C:\Hardy\Arduino\hardware -hardware C:\Users\nutzer\AppData\Local\Arduino15\packages -tools C:\Hardy\Arduino\tools-builder -tools C:\Hardy\Arduino\hardware\tools\avr -tools C:\Users\nutzer\AppData\Local\Arduino15\packages -built-in-libraries C:\Hardy\Arduino\libraries...

Ups, seems that my post before was not transfered. Here again: configuration see attachment C:\Hardy\Arduino\arduino-builder -dump-prefs -logger=machine -hardware C:\Hardy\Arduino\hardware -hardware C:\Users\nutzer\AppData\Local\Arduino15\packages -tools C:\Hardy\Arduino\tools-builder -tools C:\Hardy\Arduino\hardware\tools\avr -tools C:\Users\nutzer\AppData\Local\Arduino15\packages -built-in-libraries C:\Hardy\Arduino\libraries -libraries C:\Users\nutzer\Documents\Arduino\libraries -fqbn=esp32:esp32:esp32:PSRAM=disabled,PartitionScheme=default,CPUFreq=240,FlashMode=qio,FlashFreq=80,FlashSize=4M,UploadSpeed=921600,DebugLevel=none...

Hi Robert, please stop investigating this issue! Don´t ask me why... I have created a new folder on a different drive (C:), unzipped and compiled successfully. I do not understand why this is running now. I have the old FW version on the other drive(G:) in a different directory and there it compiles. AFter that I have deleted the folder with the 127-07 and unzipped again... and now it works also on the G:\ drive.... So the only explanation I have is that during extraction of the zip file the first...

...and to keep in mind. Compiling the 127-04 is no problem...