cups

I made the OLED version... Attached the document mySQM.pdf. Confirmed, it's on page 16... Regards, Robert. Build version: mySQM-v1-Retired. v223_OLEDI2C_NGPS_AGPS_NMEA Tested too with V006_OLEDI2C

I made the OLED version... Attached the document mySQM.pdf. Confirmed, it's on page 16... Regards, Robert. Build version: mySQM-v1-Retired. v223_OLEDI2C_NGPS_AGPS_NMEA Tested too with V005_OLEDI2C

I made the OLED version... Attached the document mySQM.pdf. Confirmed, it's on page 16... Regards, Robert.

Hi, brownrb. Finally, I've finished your mysqm project. Now it works fine (with version 223 and with the new pro version (305). But I have been fighting with the gps module (neo6m) It didn't work (no data). At least I've found the error. In your pdf, page 16, you wrote this vcc to 5v rxd to d6 rxd to d7 gnd to gnd Really must be: vcc to 5v (or 3v3) rxd to d3 txd to d4 gnd to gnd And now, it works like the charm Thans for your effort and job for all of us... Next project: your focuser. Regards from...

Hi, brownrb. Finally, I've finished your mysqm project. Now it works fine (with version 223 and with the new pro version (305). But I have been fighting with the gps module (neo6m) It didn't work (no data). At leas I've found the error. In your pdf, page 16, you wrote this vcc to 5v rxd to d6 rxd to d7 gnd to gnd Really must be: vcc to 5v (or 3v3) rxd to d3 txd to d4 gnd to gnd And now, it works like the charm Thans for your effort and job for all of us... Next project: your focuser. Regards from...

Hi, brownrb. Finally, I've finished your mysqm project. Now it works fine (with version 223 and with the new pro version (305). But I have been fighting with the gps module (neo6m) It didn't work (no data). At leas I've found the error. In your pdf, page 16 you wrote this vcc to 5v rxd to d6 rxd to d7 gnd to gnd Really must be: vcc to 5v (or 3v3) rxd to d3 txd to d4 gnd to gnd And now, it works like the charm Thans for your effort and job for all of us... Next project: your focuser. Regards from...

Hi, brownrb. Finally, I've finished your mysqm project. Now it works fine (with version 223 and with the new pro version (305). But I have been fighting with the gps module (neo6m) It didn't work (no data). At leas I've found the error. In your pdf, page 16 you wrote this vcc to 5v rxd to d6 rxd to d6 gnd to gnd Really must be: vcc to 5v (or 3v3) rxd to d3 txd to d4 gnd to gnd And now, it works like the charm Thans for your effort and job for all of us... Next project: your focuser. Regards from...

It would be possible replace the led lens 25 degree by another one (20 or 30 degrees)?...