Activity for rakesh kumar
-
rakesh kumar posted a comment on discussion Help
Good afternoon Sir, Thank you for your valuable reply . Regards Rakesh
-
Good evening Sir, sir the wind field is generated by Qblade software is based on...
-
Good eveing Sir, Thank you for your helpful reply Regards Rakesh
-
Hi David Sir Thank you for helpfull reply ,Sir i have one more question what is meaning...
-
Good morning David Sir, Sir, is it possible to get full mass and stiffness matrix...
-
Hi David Sir, Thanks for your nice reply ,Sir the formulation is given in the "Dynamic...
-
hi David Sir I am unable to match the frequency value with the matlab coding (following...
-
hi Sir, in the new version of Qblade(v0.09b) where i can get the ForceN vs Radius...
-
Hi David Sir, Sir ,I wanna use different material layers with different orientation,...
-
Hi David Sir, Sir the mass matrix i'm getting in the multiple of (some value i.e.3.789...
-
Hi David Sir, Sir , is there any such software, for blade analysis, by which i can...
-
Hi David Sir, i wanna know tht the after giving the loads on blade, we are getting...
-
hi David here is this link of blade file and images are attached , where i'm getting...
-
hi David , I'm getting problem to finding parameters of the Axial force stiffness...
-
Hi David David i Execute from zip file but still i'm getting the same error . I dont...
-
Hi David , thanks David for giving me a valuable complement,actually i'm doing matlab...
-
Hi David, how to find Polar moment of inertia about centroidal axis ,there is no...
-
Hi,David thanks for that paper Scott Larwood . David i have one more doubt .....stress...
-
Hi, david Once again i got error but this time not by zip file actually while installing...
-
Hi,David thanks for helping me. Mr.David i got that code and i have downloaded too....
-
Hi,David today i'm downloading the new version of Qblade but i am getting error just...
-
Hi, how can i get into the source code? where i can get this "TaperedElem.cpp" ?
-
Hi, how can i get into the source code?
-
Hi David I have so many doubts and you are giving me the solution, thanks for that....
-
Hi,David David, I need your help regarding how to extract the "mass and stiffness...
-
Hi This is the 2nd time when the Qblade has stopped working and then file got vanished...
-
hi David, would u please to upload a new manual i.e. Qblade v0.8 manual because the...
-
Hi anyone help me to solve my problem in fast simulation ....i m sending that file...
-
Hi David thanks for replying .yeah I've taken a small blade analysis.I'm not getting...
-
hi David i getting error while doing fast simulation (you can find the snipped file...
1