Bart Coninckx

After half an hour Pycam is still calculating but the progess bar hangs. I had this as well in the 0.5.1 version. Not sure why this happens. It does shows a warning about a missing openvoronoi library.

OK, it seems I had to explicitly select a model in the process tab. It's calculating now. BC

Hi Lars, while doing this I get: No trace models given: you need to assign a 2D model to the engraving process. my model is a SVG though, which should be 2D. What is going wrong? cheers, BC

Hi Lars, I got these high processing times while using an extruded model (see other post). If I find a way to fill in parts, I won't have to do the extrusion part again, which will benefit processing times. Regarding the version: I used the one on Sourceforge that was downloaded most. I only found 0.6.1 that was higher as a version. Where is 0.6.3 ? cheers, BC

Hi Lars, thanks! When I split the design into filled out parts and contour parts, I still face the same problem: how do I tell Pycam to fill in? Cheers, BC

I just tried to generate the toolpath for an extruded model and this indicated that the job would take 8 hours! Can this be improved? BC

Hi, using 0.5.1 on Linux Mint. The Extrude function takes a very, very longtime. Did not time it, but it is more than 15 minutes. Can this be helped? Cheers, BC

I just found out that if I click the "Extrude" button, I get the filled in parts in the example window, but while simulating still only the contours are done. BC