Activity for Barry E.
-
Barry E. posted a comment on discussion General Discussion
This is related to my previous post, where I'm loosing position data on controller power off. It seems that in v295, in the setup(), it's "moving" the data to the next EEPROM section by setting the validdata flag to 0 in the current block. However, it doesn't write the new block immediately like it did in v294. This results in a period of time (after setup() and before the next EEPROM write), that there is no EEPROM data block that is marked as valid. Long story short, a line was removed in v295...
-
I just upgraded the firmware from v270 to v295 on my Arduino-based DRV8825HW203 focuser, and am now seeing strange behavior. The Windows app (2.4.4.5) successfully connects and controls the focuser, but once I disconnect the app, wait 30 seconds, then unplug the USB cable from the Nano, it seems that it's loosing the focuser Position. Because when I plug the cable back in, reconnect the Windows app, the values are reset: Position=5000 and Max Steps=10000. If I don't unplug the cable (just disconnect...
-
Fixed in V1.15. I also updated the folder browse dialog so it's much easier to use....
-
V1.15
-
Gary, Can you confirm that your groups are separated by Temperature only and not...
-
Fixed in V1.14.
-
V1.14
-
Gary, Does DeepSkyStacker support the same file in different groups? When I was developing...
-
V1.13 now includes support for file extension filtering during load!
-
V1.13
-
Would this be a top-level setting (i.e. you set it by going to Tools->Options and...
-
V1.12
-
This bug has been fixed in V1.12. Also, if there are feature requests, please let...
-
Hi everyone. It's been a long time since I've made any changes to DarkMaster, but...
-
Gary, Can you send me some example image files that I can use to reproduce this issue?...
-
V1.11
1
