b3nz0l

i usually load tracks/points from gpx exports and sometimes open a second export file from a different device that covers the same timespan as the file loaded before. in this case instead of appending the new data to the data already loaded i would like to unbind all waypoints from their tracks and display them sorted them by timestamp

possibility to use with LO-RTE

another approach might be decreasing the opacity of not-selected points while any segment is selected/highligted according to user defined values.

yes, for the ability to select multiple ranges the proposed feature would have to be set to disabled. A Keyboard shortcut to select current segment would at least be half way to the intended feature. I usually have gpx data worth several hundred kilometers and 10-30 Days loaded that i split into segements by time limit of 15min, when i'm analysing it i usually scroll trough the points and manually trigger the segment selection when i notice i left the previously selected segment. which is getting...

this would manifest in the menu entry for Range> select current segment being an on/off switch that when enabled would trigger select current segment each time a new point is selected. to prevent affecting other manual set range selections an addtional check could be implemented wether the previously selected point was in the same range as the newly selected one and only trigger the select cur seg function if the range also differs. it might not be practical to permanently enable such a feature,...

this would manifest in an additional checkbox ind the settings that when enabled would trigger select current segment each time a new point is selected. to prevent affecting other manual set range selections an addtional check could be implemented wether the previously selected point was in the same range as the newly selected one and only trigger the select cur seg function if the range also differs. it might not be practical to permanently enable such a feature, so the possibility to enable and...

this would manifest in an additional checkbox ind the settings that when enabled would trigger select current segment each time a new point is selected. to affect other manual set range selections an addtional check could be implemented wether the previously selected point was in the same range as the newly selected one and only trigger the select cur seg function if the range also differs. it might not be practical to permanently enable such a feature, so the possibility to enable and disable it...

this would manifest in an additional checkbox ind the settings that when enabled would trigger select current segment each time a new point is selected. to reduce the possible impact on performance an addtional check could be implemented wether the previously selected point was in the same segment as the newly selected one and only trigger the select cur seg function if the segment also differs. it might not be practical to permanently enable such a feature, so the possibility to enable and disable...