Andres Ovalle

Increased size of base voltage array from default 200 to 300. Used in GICharm as a wide range of bases may exist in those models.

Updated "Show" fault study report to better arrange output. Using this in DPAT for DSS. Pending to migrate DPAT to use of "Export" report instead.

Minor update and bugfix to 'ALL-Node Fault Currents' part of ShowFaultStudy procedure. Bus name was not being printed in the report as it was left out of a conditional compilation statement. Also removed commas to match the other two parts of the report ('ONE-Node to ground Faults' and 'Adjacent Node-Node Faults').

Adding global variable called "AutoDisplayShowReport" and associated code. Setting it to True by default to avoid changing any existing behavior. The purpose is to disable it when needed to avoid firing the text editor on Show commands. The behavior is similar to that of ShowExport.

Updates to long-line correction. Added Circuit parameter LongLineCorrection (False by default) to apply long-line correction where feasible (lines with symmetrical components model). Long-line correction also applied to zero sequence is 3-ph line. Setting this parameter changes YprimInvalid (for enabled line objects with symmetrical components) to True.

Training materials - Basics and scripting

Solved issue introduced with long-line correction changes of rev 3464. Single-phase lines without symmetrical component definition were being affected by change.

Fixed long-line correction bug in Line.pas. It used to be applied only to base frequency and parameters were scaled for frequency changes in harmonics mode. This commit updates DoLongLine to be used in CalcYPrim instead of RecalcElementData. It also corrects the positive sequence attributes temporarily for every tested frequency rather than updating the initial values for X1, R1 or C1. Updates were tested on IEEE 14-bus model resulting in matching results to those reported by the harmonics ta...