Abdullah Al Mamun

Hi Mr. Dugan, I know this is an old post but I have similar question to this one. If I want to power up an islanded system with a Vsource, how can I make sure that the Vsource doesn't act as a traditional substation and power up the whole MG? Because, I want to power the MG with Generators that I have added to it. I want the Vsource there just as a reference. Also, I need to run the simulation in Snapshop mode due to system requirements. Thank you. Regards Mamun

Hi, In one of my test system, I have a traditional Voltage source and bunch of loads in the circuit. However, I have added several DGs into the system from which one will act as a GFM by replacing the voltage source and others will be GFL. I want to model the GFM DG as a fixed P,Q output device like "model=7" where I will command it to provide a fixed P and Q value. I will run the system in snapshot mode. Is this possible in current OpenDSS setup. If not what could be the best alternative? My system...

Hi Dr. Tuffner, Is there any working script to populate IEEE test feeders with Houses? or are there any already built and tested test feeders with Houses? Thank you. -Abdullah

Hi Dr. Tuffner, Is there any working script to populate IEEE test feeders with Houses? or are there any already built and tested test feeders with Houses? Thank you. -Mamun

Hi, I am wondering if there is any repository which has IEEE test feeders models with houses? For example IEEE-13, 123 etc. Or, if there is any updated script which will populate any IEEE test case system with houses? This would be really help.

Hi, I am wondering if there is any repository which has IEEE test feeders models with houses? For example IEEE-13, 123 etc. Or, if there is any updated script which will populate any IEEE test case system with houses? This would be really help.

Thank you, Dr. Tuffner for the information. -Abdullah

Hi Jerry, It would be really helpful if you could share the solution in details here. I am new to GridLAB-D. Thank you.