Moi

Hi Really good job ! and thanks a lot for reply

Hello I do not know if you can do that but if yes i like to get a bootloader for the pic 18F16Q41 If this is possible i like it 115200bds using RC5 as Rx and RC4 as TX. (also code read protection) Thanks, best regards

thanks a lot, file edited with gq-4x mcumall interface i haven't found how to do that with Mplab IPE

file is not like yesterady it seem ok opened it again. But i do not understand why is really big your boot code stop here 103FF000 and the dump continu until 10DFF000 I all way the config page from gq-4x does not report the same value as your report like PLL and LVP

ok i have see the tool "mplab ipe" i will try that, thanks a gain

but it seem my programers gq-4x usb does not set the bit correctly and trying to save the modified config the saved file will be broken (garbage like only a line FFFFFFFFFFF

Hello It seem to work fine, many thanks !! Can i ask a version with CPD_ON & CP_ON also _PLLEN_ON Really cool to use a working bootloader another thanks

for now i have set : defaults,1F80-1FFF trying other value cause error. If you bootloader take care to write provided file at the good adress (0x4) i think the good settings can be : defaults,1F7B -1FFF edit : i havec badly read you suggest to protect x100 so it will be "defaults,1EFF -1FFF" that allow to already add enough some space for the first 4 bytes