Activity for Moi
-
Moi posted a comment on discussion Requests
Hi Really good job ! and thanks a lot for reply
-
Hello I do not know if you can do that but if yes i like to get a bootloader for the pic 18F16Q41 If this is possible i like it 115200bds using RC5 as Rx and RC4 as TX. (also code read protection) Thanks, best regards
-
thanks a lot, file edited with gq-4x mcumall interface i haven't found how to do that with Mplab IPE
-
file is not like yesterady it seem ok opened it again. But i do not understand why is really big your boot code stop here 103FF000 and the dump continu until 10DFF000 I all way the config page from gq-4x does not report the same value as your report like PLL and LVP
-
ok i have see the tool "mplab ipe" i will try that, thanks a gain
-
but it seem my programers gq-4x usb does not set the bit correctly and trying to save the modified config the saved file will be broken (garbage like only a line FFFFFFFFFFF
-
Hello It seem to work fine, many thanks !! Can i ask a version with CPD_ON & CP_ON also _PLLEN_ON Really cool to use a working bootloader another thanks
-
for now i have set : defaults,1F80-1FFF trying other value cause error. If you bootloader take care to write provided file at the good adress (0x4) i think the good settings can be : defaults,1F7B -1FFF edit : i havec badly read you suggest to protect x100 so it will be "defaults,1EFF -1FFF" that allow to already add enough some space for the first 4 bytes
-
Trying this settings i get : ::: warning: (1394) attempting to create memory range (4 - 1f80) larger than page size 800 edit : Rom ranges : 1f80-1FFF seem to do the job But what about bytes 0 to 3 ? they can be overwritten without issue ?
-
Trying this settings i get : ::: warning: (1394) attempting to create memory range (4 - 1f80) larger than page size 800
-
Trying this settings i get : ::: warning: (1394) attempting to create memory range (4 - 1f80) larger than page size 800
-
like Rom ranges : 04-1f80
-
Thanks a lot, i will try it soon (need some days before getting the pic from seller) Is there something to configure in mplab x ide for compiling my project in the way needed for use bootloader ? Br
-
Hi After speaking with you on another topic i likle if you can share a bootloader for this pic 16F1825 If this is configurable i like to use default RX TX pin RC5 RC4. Thanks a lot
-
Hello Firstly thanks for sharing your bootloader ! But i'm completly loste with available files, i like to found a bootloader UART for 16F1825 this one seem to be in the compatibility list but the file are missing. Reading this post you says "PING ME for a sample HEX!!" so is possible to have something ? Best regards
1
