Andreas Exeler

Hello Robert, I built a new rotator with a Hal-sensor on a loose cable, so I can test better with the magnet. I've noticed that if I don't enable "Homesensor" everything works fine. If I then set the home sensor enable, homing runs once!!! But the "value" remains true even if the magnet is gone or I move to a new angle. (then homeing only takes one step). Only when I unplug the sensor does the value go to false, when I then reconnect it, the value remains false and I can make a new home run, then...

Hello Robert, I built a new rotator with a Hal-sensor on a loose cable, so I can test better with the magnet. I've noticed that if I don't enable "Homesensor" everything works fine. If I then set the home sensor enable, homing runs once!!! But the "value" remains true even if the magnet is gone or I move to a new angle. (then homeing only takes one step). Only when I unplug the sensor does the value go to false, when I then reconnect it, the value remains false and I can make a new home run, then...

Hi Robert, i uninstall the app, install the 2_4_0_7. Connect to the Rotator, App shows 0° Angle, move to 45° and then press Home: The Stepper moves about 5° then stops, sorry. Greets Andreas

Hi Robert, i am so sorry. i think i build a second one, so i can check if i had a mistake in the build or something is broken. greets Andreas

Hi Robert, sure, but sorry, it is the same. after connect the Angle was 0 in the APP (the Rotator was real about ca. 60°), i Move to 45 and after reache the 45° i press Home, the angle in the app jumps to 0, the Stepper makes one step. i am so sorry. Gretts Andreas

Hi Robert, thats good news. Take the time you need. Thanks for the Support. greetings Andreas

Hi Robert, i flash the 2024-10 again. No disconnect any more, but at press Home the same as the last: only one step. Can now press Halt and Move again and there is no disconnect! pls see the log. Thanks for help. greets Andreas

Hi Robert, i use Rotator with a DRV8825. i try the 2024_10, but no Homeing, only on step. The move works. After press Home the Ardunio disconnect from thr APP. Sorry. Greets Andreas