The experimental version has initial (incomplete) support to other microcontrollers using picsim, simavr, qemu-stm32, uCsim and gpsim as backend simulator and some new boards.
The PICSimLab_NOGUI version is to be used on a terminal and must be used with the remote control interface.
v0.8.6 (2021-01-25)
New
-
Part DC Motor added. [lcgamboa]
-
Part encoder (rotary) added. [lcgamboa]
-
Support to configure remote control port number in configuration window. [lcgamboa]
-
Push buttons and potentiometer animation implemented. [lcgamboa]
-
New part rotary potentiometer. [lcgamboa]
-
Support to active parts with low input signal for LEDs, RGB LED, Buzzer and 7 segments display. [lcgamboa]
-
Support to save board potentiometers position. [lcgamboa]
-
Initial support to TCP remote control interface. [lcgamboa]
-
Initial support to touch controller xpt2046. [lcgamboa]
-
Support to read in ili9340 8 bit interface added. [lcgamboa]
-
Support to set offset in Signal Generator added. [lcgamboa]
-
Support to qemu_stm32 analog channels added. [lcgamboa]
-
Support to ili9341 8 bit parallel mode added. [lcgamboa]
Fix
-
Correct state of uart txpin on reset fixed. [lcgamboa]
-
Serial bitbang tx bug fixed. [lcgamboa]