LinuxCNC Reviews

5.0 out of 5 stars

★★★★★

★★★★

★★★

★★

★

ease 1 of 5 2 of 5 3 of 5 4 of 5 5 of 5 4 / 5

features 1 of 5 2 of 5 3 of 5 4 of 5 5 of 5 5 / 5

design 1 of 5 2 of 5 3 of 5 4 of 5 5 of 5 5 / 5

support 1 of 5 2 of 5 3 of 5 4 of 5 5 of 5 5 / 5

Rate This Project

User Reviews

Filter Reviews:

lakeweb Posted 2020-10-20

I bought an older Topwell 3VK that was powered by Analam on EBay. I did get it to run, (would not boot when I got it), but it was a cranky and old controller. So I kept the servo drivers, (SD-1525) on out and using the Mesa 7i77 and 7i92 got it up and running on LinuxCNC! It became a delightful machine! Thanks for making it possible.
todd-z Posted 2017-06-08

Excellent CNC control software for any machine from a simple hobby-ist's router to large industrial machinery. It does have a steep learning curve for anyone not familiar with the operation of CNC controls or configuring them. Actual installation of the software is very simple with the live ISO.
tfileme Posted 2013-05-17

Very good Software.

1 user found this review helpful.
bookavop Posted 2012-10-24

Easy install and setup! works great.
pepele Posted 2011-06-10

right out of the box, (actually just a download) I was able to connect to a PPMC controller and give commands.
zarthrag Posted 2011-05-03

I just constructed a fully featured cnc machine. Getting EMC up and running is miles beyond every other option out there (and arguably better than Mach3). But it's free! The community is fantastic, and there is unlimited potential to customize and improve things.