debugger ignores breakpoints / psgml starts in read only (debugger) mode

[Patrick D. <pd...@gm...>]

Hello,

I am trying to setup XSLT-process 2.1 under emacs 21.1.1 running on Windows
XP. I have discovered two problems:

1.
When I try to run Saxon on the current buffer everything works, XSLT-process
processes the xml file and the xsl file and shows the resulting output in
the *xslt results* buffer. If I try to use the debugger my breakpoints are
ignored and XSLT-process simply does exactly the same as described above. It does
not stop at any breakpoint. I try to start the debugger like this:
- I load the xml file and xsl file
- I toggle the buffer with the xsl file into debug mode
- I set a few breakpoints in the xsl file with the "b" command.
- I switch into the buffer with the xml file
- I toggle this buffer into debug mode
- I start the debugger with the "r" command.
Any ideas why XSLT-process is not stopping at my breakpoints?

2.
I have another problem when using psgml 1.2.3 for xml editing. After opening
a xml file, the buffer is read-only and the XSLT-process menu is in
"debugger-mode". The modeline still shows XSLT though, not XSLTd. If I am using the
standard xml (sgml) mode that is coming with emacs the behavior is ok, so it
must be a problem with psgml and XSLT-process. I have seen Eugene Gross
describing the same problem on this mailing list in a mail from 08/08/2001 but
there was no resolution posted.

XSLT-process is a very good tool despite these problems, but with xslt
debugging working it would be really great!

Patrick

-- 
GMX - Die Kommunikationsplattform im Internet.
http://www.gmx.net