Re: [Xc3sprog-users] Use SST Serial SPI Flash with Spartan 3E board ?

[Shanjit S. <sha...@gm...>]

I am more than happy to get my hands dirty! Any pointers ?

--
Shanjit Singh Jajmann
Final Year Undergraduate Student,
Netaji Subhas Institute of Technology,
University of Delhi, India
+91-9013523548
http://www.shanjitsingh.in


On Sat, Mar 30, 2013 at 11:24 PM, Uwe Bonnes <
bo...@el...> wrote:

> >>>>> "Shanjit" == Shanjit Singh <sha...@gm...> writes:
>
>     Shanjit> Hello, I am trying to make my own custom XC3S250E based
>     Shanjit> board. Can i use XC3Sprog for programming my SST based Serial
>     Shanjit> Flash which is connected to my FPGA using a Digilent Adept
>     Shanjit> based programmer ?
>
> To reply like radio eriwan:
>
> "In principle yes"
>
> But I have no access to that special combination and so have not tested
> it. There might miss small pieces, e.g. the FLASH ID or perhaps even the
> Flash has a slightly changed algorithm. But even then it should be doable
> to
> worked it out with some effort.
>
> Bye
> --
> Uwe Bonnes                bo...@el...
>
> Institut fuer Kernphysik  Schlossgartenstrasse 9  64289 Darmstadt
> --------- Tel. 06151 162516 -------- Fax. 06151 164321 ----------
>